78
11BOAT MAINTENANCEBOAT MAINTENANCEBOAT MAINTENANCEBOAT MAINTENANCEBOAT MAINTENANCEBOAT MAINTENANCEBOAT MAINTENANCEBOAT MAINTENANCEBOAT MAINTENANCEBOAT
12ProblemCauseFixSpeed Control does not operate.1. Transmitter and/or receiver is not switched on.1. Switch on.2. Batteries are not fully charged.2. C
13SETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP
14SETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP NOTESSETUP
15BATTERYBOAT WEIGHT AND SETUP SPECS
1816Venom Group International14028 N. Ohio StreetRathdrum, ID 83858Customer [email protected] (outside US
SAFETY PRECAUTIONSSAFETY PRECAUTIONSSAFETY PRECAUTIONSSAFETY PRECAUTIONSSAFETY PRECAUTIONSSAFETY PRECAUTIONSSAFETY PRECAUTIONSSAFETY PRECAUTIONSSAFETY
Thank you for purchasing your new Venom™ King of Shaves P1 35” RTR Electric Boat. This RTR Electric Boat was designed with both beginning R/C Boat hob
41) Press enter to access the function menu.2) Press the Key 4 times to highlight the “mdl” (model) menu and press the “Enter” key.3) With
5STEP #1. Enter the programming mode.Switch on the transmitter. Move the throttle trigger to the Full throttle position and then connect the battery
6 Slide the prop onto the drive shaft making sure to align the notch with the drive dog. Use the supplied lock nut to secure the prop to the propshaft
71. Thread the antenna from inside the hull up through the base of the antenna tube holder. 2. Thread the antenna through the antenna tube.
8Secure the hatch by sliding the front pin into the hole at the front of the hull opening. The Hatch should drop easily down so that the magnets hold
9See page 6 Loosen the drive using a pair of needle nose pliers and a 2.5mm Hex Driver. Adjust the drive up or down to change the running angle of the
Comments to this Manuals